We are trying to use TV version 9 (free) and have hit the firewall. SEP will not let the connection through althorugh we have plenty of connectivity in the browser, other applications etc. TV is the only one SEP is blocking.
How do I know SEP is blocking? Well, I diabled the SEP firewall by disabling it. TV then worked fine. Turned firewall back on, TV fails again.
I've created a special TV firewall rule and set it at the top of the firewall rules stack. In there I have set it up like this:
Note: Scheduling is completely disabled on the fifth tab.
Here's the traffic log with this enabled and in place: (I hope this frame is large enough - I'll try to split the view into two frames...)
Left side:
Right side:
I don't see any "Rule" entitled "Block_all". Notice too that the Remote/Local Hosts names are not valid IP's.
I wish SEP had a more "interactive" mode where I could get it to tell me with a pop-up what it's blocking but there doesn't seem to be any. I probably could figure it out from that, but...
Does anyone know how to poke a hole in this firewall to allow this applicaiton out into the world?
Thanks for any advice.
H